Cameras, privacy and door intercom

View cones of cameras and motion detectors, the note when a camera films beyond your plot, mask zones and the door intercom as a 2-wire bus or IP with PoE.

You place cameras, motion detectors and the door intercom like any other device from the catalog Smart home, security & audio. RoomPlanning shows what each camera and each detector sees, warns you when a camera films beyond your plot and notes how the door intercom is connected. All of it is free.

Open the template in the editor

View cones

Every camera and motion detector shows a view cone in the plan: its opening angle and range, cut off at the walls. Cameras see through windows and open passages, motion detectors only through passages; doors count as closed. You turn a device like any object, and the cone turns with it.

Without values of its own, a device uses these:

DeviceOpening angleRange
Dome camera100°15 m
Bullet camera80°25 m
Motion detector, indoor110°10 m
Motion detector, outdoor140°12 m

Select the device. Under Field of view you set the Opening angle and the Range. You switch the cones of all devices on and off with Show view cones in the Cameras and door intercom panel (tool Network & smart home). They are on the Network & smart home layer. In 3D, a selected camera shows its cone as a see-through fan.

Cameras and privacy

Private cameras may only cover your own plot. If a camera films the pavement, the street or the neighbour's plot, the GDPR applies and the household exemption no longer does (CJEU, judgment C-212/13, Ryneš). This is a note, not legal advice.

For RoomPlanning to check this, draw your plot with the Lot tool under Outdoor. Without a plot, the Cameras and door intercom panel says "Draw the plot to check".

If a camera's cone reaches beyond the plot, RoomPlanning colours that part red and says how many square metres lie outside. Three ways lead back onto your own plot:

  1. Turn it: point the camera along the driveway or the garden instead of at the street.
  2. Shorten the range: set a smaller Range under Field of view.
  3. Mask it: modern cameras black out areas of the picture. Mask outside lays mask zones exactly over the part outside the plot. To make one yourself, use Mask zones: From and To are angles from the left edge of the cone, seen from the device, From distance is where the zone begins. Add zone adds it, Remove takes it away. A device has at most eight zones, grey in the plan.

Set the same masking on the camera itself. The plan only records what the camera should not record.

Door intercom

The door station belongs on the outer wall beside the front door or on the fence by the gate, the indoor station in the hall or the kitchen. They are connected in one of two ways:

  • 2-wire bus: a bus circuit with J-Y(St)Y 2×2×0.8. It is inexpensive and enough for the bell, speech and usually video.
  • IP with PoE: a data circuit with Cat.7 to the switch. Power comes over the network cable, and the picture can be forwarded to a phone.

With the Network & smart home tool, draw a cable of the cable type Bus (KNX, door intercom) or Network (LAN) to the station and assign the station to the circuit. The Cameras and door intercom panel then shows the system, the number of stations and what is missing: an indoor station, a door station at the front door or gate, a station without a circuit, or stations on bus and data circuits at once. The bill of materials takes the system from there.

Guideline heights: door station 1.40 to 1.60 m (centre of the camera), indoor station 1.40 to 1.50 m. The door opener sits in the door frame.

Good to know